Wipers Blades Do Not Park - GMC Chevrolet Camaro 1998 Service Manual

8-172 Wipers/Washer Systems
Body and Accessories
Wipers Always On (cont'd)
Step
Action Value(s) Yes No
Replace the wiper motor cover. Refer to Wiper Motor
Go to
15
Cover Replacement.
-
Wiper/Washer
-
Is the replacement complete? System Check
Repair the short to voltage in CKT 113. Go to
16
Is the repair complete?
-
Wiper/Washer
-
System Check
Wipers Blades Do Not Park with Switch Off
Step
Action Value(s) Yes No
Was the Wiper/Washer System Check performed? Go to
1
-
Wiper/Washer
Go to Step2 System Check
1. Turn the ignition switch to RUN.
2
2. Turn the wiper switch to OFF.
-
3. Disconnect the wiper/washer switch connector C215.
Do the wipers park? Go to Step 3 Go to Step 4
Replace the wiper/washer switch. Refer to Turn Signal and
Multifunction Switch Assembly - Disassemble - Off Vehicle
3
and Turn Signal and Multifunction Switch Assembly -
-
Go to
-
Assemble - Off Vehicle.
Wiper/Washer
Is the replacement complete? System Check
Measure the voltage from connector C215 (vehicle side),
4
terminal E, to ground with a DMM.
1.0 V
Is the measurement greater than the specified value? Go to Step 10 Go to Step 5
Measure the voltage from connector C215 (vehicle side),
5
terminal F, to ground with a DMM.
1.0 V
Is the measurement greater than the specified value? Go to Step 7 Go to Step 6
(
Replace the wiper motor cover. Refer to Wiper Motor
Go to
6
Cover Replacement.
-
Wiper/Washer
-
Is the replacement complete? System Check
1. Reconnect the wiper/washer switch connector C215.
2. Disconnect the wiper motor connector.
7
3. Measure the voltage from the wiper motor connector,
1.0 V
terminal E, to ground, with a DMM.
Is the measurement greater than the specified value? Go to Step 12 Go to Step 11
Replace the wiper motor cover. Refer to Wiper Motor
Go to
8
Cover Replacement.
-
Wiper/Washer
-
Is the replacement complete? System Check
Repair the short to voltage in CKT 112. Go to
9
Is the repair complete?
-
Wiper/Washer
-
System Check
1. Reconnect the wiper/washer switch connector C215.
2. Disconnect the wiper motor connector.
10
3. Measure the voltage from the wiper motor connector,
1.0 V
terminal D, to ground, with a DMM.
Is the measurement greater than the specified value? Go to Step B Go to Step 7
Replace the wiper motor cover. Refer to Wiper Motor
Go to
11
Cover Replacement.
-
Wiper/Washer
-
Is the replacement complete?
System Check
Repair the short to voltage in CKT 113. Go to
12
Is the repair complete?
- Wiper/Washer
-
System Check
(