GMC Chevrolet Camaro 1998 Service Manual page 178

1.;sa HVAC System - Manual
J 34614
210212
HVAC
Notice:
Any attempt to use makeshift or inadequate
service tools or equipment may result.in damage
and/or improper compressor operation.
3. Assemble the 0-ring onto the J 33011.
4. Install the 0-ring.
4.1. Insert the J 33011 into the compressorneck
until the installer bottoms 01,.1t.
Important: The top groove in the compressor neck is
for the shaft seal retainer ring.
4.2. Lower the moveable slide of the J 33011 in
· order to. release the 0-ring into the seal
0-ring lower grove.
4.3. Ro.tate the J 33011 in order to seat .the
0-ring.
4.4. Remove the installer.
5. ' Dip the new shaft seal in clean 525 viscosity
refrigerant oil.
6. Assemble the seal to the J 23128-A by turning the
, handle clockwise.
6.1.
Ensure. that the stamped steel case sid.e of
the lip seal engages with the knurled tangs
of the J 23128~A.
6.2. Ensure that the nil.red-out side of the lip
seal faces toward the compressor.
Notice: U&S care when handling the seal protector.
Do not nick the seal protector. This may damage '
the seal during installation. Ensure that the bottom of
the seal protector is not flared. This may damage
the seal during installation.
7. Install the J 34614 on the lip seal.
8. Install the lip seal onto the shaft.
8.1. Place the J 34614 over the end of the
compressor shaft.
8.2. Slide the new seal onto the shaft using a
rotary motion of the J 23128-A.
8.3. Ensure, that the seal makes good contact
with the 0-ring.
Do not dislodge the 0-ring.
8.4. Disengage the J 23128-A from the seal.
8.5. Remove the J 23128-Aand the J 34614
from the compressor.
(
(