GMC Chevrolet Camaro 1998 Service Manual page 176

1-66 HVAC System - Manual
6997
J 8433-1
J 8433-3
237122
)
/
J
34992
237119
HVAC
9. Stake the front head at 3 places 120 degrees
apart in order to ensure that the clutch coil
remains in position. ·
10. Ensure that the stake size is only one half of the
area of the punch tip and only 0.28-0.35 mm
(0.010-0.015 in) in depth.
11 . With the compressor mounted to the J 34992,
position the rotor and bearing assembly on the
front head.
12. Position the J 33017 and the J 33023-A directly
over the inner race of the bearing.
13. Position the J 8433-1 on the J 33023-A.
14. Assemble the two through bolts and the washers
of the J 34992 through the slots of the J 8433-1.
15. Thread the two through bolts into the J 34992.
Ensure that the thread of the through bolts
engages the full thickness of the J 34992.
16. Tighten the J 8433-3 in the J 8433-1 in order to
force the pulley rotor and bearing assembly onto
the front head of the compressor.
17. If the J 33017slips off direct, in-line contact with
inner face of the bearing, use the following steps:
17.1. Loosen the J 8433-3.
17.2. Realign the J 33017 and the J 33023-A in
order to ensure that the installer clears the
front head.
18.
Install the rotor and bearing assembly retainer
ring using the J 6083.
19. Install the clutch plate and hub assembly. Refer to
Compressor Clutch Plate/Hub Assembly Install
(VS - Conventional Mount).
20.
Install the shaft nut.
(
(