GMC Chevrolet Camaro 1998 Service Manual page 174

t..;64
HVAQ System·~ Manual
J
33013,::-13 .
157226
J
41790
157223
Clutch Rotor•and/or. Bearing Install
(V7 -· Direct Mount)
Tools Requir_ed
HVAC
• J 33013-B Hub and Drive Plate Remover/Installer
• J 33017 Pulley and Bearing Assembly Installer
t.
Pesition the clutch ·rotor.·and·bearing assembly (2)
6ritcfthe compressor.
2. Position the J 33017 and bearing (1) from the
J 3301$--B directly over the inner race of the
bear1ng,,, · · ·
3. Place the washer, (3) from the .J 42126 tool kit
onto the body of the J 33Q 13-8.
4. Remove the center screw from the body of the
J.33013-8.
5. tnstall ttte center screw into the opposite end of
the J 33013-B.
q,
.Back the body of the J 33,013-8
.off
enough to
· · a!lolJI.{ the c~nt~r sprew to be threaded onto the
end of the compressor shaft.
7. Thr'3ad the center screw several turns onto the
end of the compressor shaft
Do not tigl)te.1;1.the.center screw
on
the
coroi:>re~pr shaft,
8. Hold the center screw with a wrench.
9. Tighten the hex portion of the J 33013-8 body
several turns.
10. Remove the J 33013-8 from the clutch rotor and
bearing assembly.
11 . Make sure that the clutch rotor and bearing (2) is
pressed onto the nose of the compressor far
enough to clear the groove for the retaining ring.
If the clutch rotor and bearing does not clear
the groove, repeat steps 7, 8 and 9.
12. Install the clutch rotor and bearing retaining
ring (3) using external snap ring pliers (1).
Make sure that the camphor side of the retaining
ring is facing up when the retaining ring is
being installed.
13. Install the clutch plate and hub assembly. Refer to
Compressor Clutch Plate/Hub Assembly Install
(V7 - Direct Mount).
14. Remove the compressor from the J 41790.
15. Install the compressor into the vehicle.
(
(