GMC Chevrolet Camaro 1998 Service Manual page 156

1-46 HVAC System - Manual
365448
237075
237077
5. Install a new 0-ring.
Lightly coat the 0-ring with a mineral base
525 viscosity refrigerant oil.
6. Install the A/C compressor and condenser
hose bolt.
Tighten
HVAC
Tighten the A/C compressor and condenser hose
bolt to 33 N,m (24 lb ft).
7. Install the serpentine drive belt. Refer to Drive
Belt Replacement (AIC) in Engine Mechanical.
8. Lower the vehicle.
9. Recharge the A/C system. Refer to Refrigerant
Recovery and Recharging.
10. Perform a leak test on the A/C system. Refer to
Leak Testing.
Compressor Clutch Plate and Hub
Assembly Removal
(VS - Conventional Mount)
Tools Required
• J 33022 Shaft Nut Socket
• J 33027-A Clutch Hub Holding Tool
• J
33013-8 Hub And Drive Plate Remover And
Installer
• J 34992 Compressor Holding Fixture
1 . Clamp the J 34992 in a vise.
2. Attach the compressor to the holding fixture using
the thumb screws.
3. Use the J 33027-A in order to prevent the clutch
hub and drive plate assembly from turning.
4. Use the J 33022 in order to remove the shaft nut.
5. Thread the J 33013-8 into the hub.
6. Use a wrench in order to hold the body
of the J 33013-8.
7. Turn the center screw into the body of the
J 33013-8 in order to remove the clutch plate and
hub assembly.
8. Remove the shaft key. Retain the shaft key for
reassembly.
(
(
(