Blower Motor Relay Replacement - GMC Chevrolet Camaro 1998 Service Manual

)
HVAC
6. Install the accumulator bolt (2) at the module.
Tighten
Tighten the accumulator bolt (2) at the module to
16 N-m (12 lb ft).
7. Connect the A/C compressor and condenser hose
bolt at the accumulator.
Tighten
Tighten the A/C compressor and condenser hose
bolt at the accumulator to 16 N-m (12 lb ft).
8. Recharge the A/C system. Refer to Refrigerant
Recovery and Recharging.
9. Perform a leak test on the A/C system. Refer to
Leak Testing.
Blower Motor Relay Replacement
Removal Procedure
1. Remove the driver side 1/P insulator. Refer to
Insulator Replacement - IP (Left Side) in
Instrument Panel, Gauges and Console.
2.
Remove the knee bolster. Refer to Knee Bolster
Replacement in Instrument Panel, Gauges and
Console.
3. Remove the blower motor relay from the
1/P tie bar.
4. Disconnect the electrical connector from the
blower motor relay.
Installation Procedure
1. Connect the electrical connector to the blower
motor relay.
2. Install the blower motor relay to the 1/P tie bar.
3. Install the knee bolster. Refer to Knee Bolster
Replacement in Instrument Panel, Gauges and
Console.
4. Install the driver side 1/P insulator. Refer to
Insulator Replacement - IP (Left Side) in
Instrument Panel, Gauges and Console.
HV AC System - Manual 1-91
365453
365453