Heater/Bi-Level Actuator Replacement; Ip Air Outlet Ducts Replacement - GMC Chevrolet Camaro 1998 Service Manual

1-108 HVAC System - Manual
365458
365458
HVAC
Heater/Bi-Level Actuator Replacement
Removal Procedure
1. Remove the 1/P carrier. Refer to IP Carrier
Replacement in Instrument Panel, Gauges
and Console.
2. Remove the front floor air outlet bolt.
3. Remove the front floor air outlet.
4. Remove the module cover screws.
5. Remove the module cover.
6.
Remove the screw from the bi-level mode linkage.
7.
Remove the bi-level actuator and linkage.
Installation Procedure·
1. Install the bi-level actuator and linkage.
Notice: Refer to Fastener Notice in Cautions and
Notices.
2.
Install the bi-level mode valve linkage screw.
Tighten
Tighten the bi-level mode valve linkage screw to
2.3 N·m (20 lb in).
3. Install the module cover.
(
4.
Install the module cover screws. (
5. Install the front floor air outlet.
6.
Install the front floor air outlet bolt.
Tighten
Tighten the front floor air outlet bolt to
1.9 N·m (17 lb in).
7. Install the 1/P carrier. Refer to IP Carrier
Replacement in Instrument Panel, Gauges and
Console.
IP Air Outlet Ducts Replacement
Pontiac vehicles have the following air deflectors:
• The right (passenger side) air deflector
• Three center air deflectors
Complete the following steps in order to remove any
of the deflectors:
1.
Close the deflector.
2. Gently ease the deflector and the housing from
the instrument panel.
The left (driver side) air deflector is part of the
instrument panel cluster trim plate. Refer to Trim Plate
Replacement - IP Accessory (Pontiac) in Instrument
Panel, Gauges and Console.
Chevrolet vehicles have the following air deflectors:
• The right (passenger side) air deflector
• The left (driver side) air deflector
• Two center air deflectors
(