Fog Lamp Replacement - GMC Chevrolet Camaro 1998 Service Manual

8·118 Lighting Systems
379382
Body and Accessories
Headlamp Aiming (Alternate Procedure)
Tools Required
J 25300-E
Headlamp Aimer (Mechanical Type), or (
equivalent
Important: When using headlamp aiming equipment
which attaches to the headlamps with a suction
cup type devise, DO NOT leave the headlamps on
while the equipment is attached. On vehicles with
plastic headlamps (body styled composite or sealed
beam) having the headlamps illuminated when
the equipment is attached, may cause heat build-up
combined with the suction cup may cause the
plastic headlamp lens to become distorted; requiring
lamp replacement.
1. Prepare the vehicle for checking beam aim as
follows:
• Place the vehicle on a flat surface.
• Remove large amounts of mud or ice from the
underside of the fenders, if necessary.
• Check whether tires are noticeably deflated •
and inflate if necessary:
• Ensure there is no load in the vehicle other
than the driver.
• Rock the veh.icle sideways to stabilize the
suspension.
• Clean the headlamp lenses and aiming pads.
2. Refer to the manufacture's instruction for the
correct operation of the headlamp aiming
equipment. (
Fog Lamp Replacement - Front (Chevrolet)
Removal Procedure
1. Remove the headlamp. Refer to Headlamp
Replacement (Chevrolet).
2. Loosen the front fender front reinforcement nut, if
necessary.
3. Disconnect the electrical connector and bulb from
the lamp socket.
(