Table of Contents
Advertisement
HOME
CENTER TAIL LOOP: ULYSSES MODELS
DISASSEMBLY
1.
Remove seat.
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explosion,
which could result in death or serious injury. (00049a)
2.
Disconnect battery cables from battery: negative cable
(black) first.
NOTE
Before removing center tail loop, it will be necessary to remove
certain components of the luggage system. See
GAGE:
XB12XT.
3.
See
Figure
2-173. Remove two fasteners securing trunk
pan to center tail loop (1).
4.
Remove cable strap from wire harness and seat latch
cable.
5.
Remove wire cover (3) on bottom side of license plate
bracket (2) in order to access wires.
6.
Disconnect:
a.
Right turn signal connector [18].
b.
Left turn signal connector [19].
c.
License plate lamp connector [45].
d.
Tail light connectors [93].
e.
Auxiliary power outlet [180].
7.
Remove rear trunk pan fasteners to center tail loop (10).
8.
Remove fasteners securing left and right tail sections to
center tail loop.
9.
Remove center tail loop from vehicle.
NOTE
To further disassemble center tail loop see the following:
6.19 TAIL LAMP
6.20 LICENSE PLATE LAMP ASSEMBLY
6.15 FRONT TURN SIGNALS
2.53 TRIPLE TAIL: ULYSSES
4.9 BANK ANGLE SENSOR (BAS)
ASSEMBLY
1.
Install center tail loop around left and right tail sections.
2.
Install fasteners securing left and right tail sections to
center tail loop but do not tighten.
3.
Install two fasteners securing trunk pan to center tail loop
but do not tighten.
4.
Route wire harness and auxiliary power outlet under seat
latch bracket.
5.
Tighten nuts of left and right tail sections to 20-22 ft-lbs
(27-30 Nm). Repeat to verify torque.
6.
Connect:
a.
Right turn signal connector [18].
b.
Left turn signal connector [19].
c.
License plate lamp connector [45].
d.
Tail light connectors [93].
e.
Auxiliary power outlet [180].
7.
Install cable strap.
8.
Install wire cover (3) on bottom side of tail loop (1) and
license plate bracket (2).
2.54 LUG-
9.
Tighten fasteners.
a.
Wire cover screws to 36-48 in-lbs (4-5.4 Nm).
b.
Install license plate light fasteners and to 12-36 in-
lbs (1.4-4 Nm).
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
10. Connect battery cables to battery: Positive cable (red) first.
Tighten to 72-96 in-lbs (8-11 Nm). See
MAINTENANCE.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
11. Install seat.
2.44
1.5 BATTERY
2009 XB Service: Chassis 2-145
Advertisement
Chapters
Table of Contents
