Buell 2009 XB Series Service Manual page 555

HOME
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
10. Install seat and pillion.
sm00434
1
3
1. Frame lug
2. Wire harness
3. Cable
Figure 6-112. Correct Cable Routing Behind Frame Lug
(Typical)
LIGHTNING
Removal
1. Remove seat.
2. Remove intake cover assembly. See
COVER.
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
3. See Figure 6-113. Remove negative battery cable (3) from
battery. See 1.5 BATTERY
4. See Figure 6-114. Separate exhaust actuator harness
connector [161B] (2) at main harness.
5. See Figure 6-113. Remove the exhaust actuator ground
(4).
6. Pull actuator harness through frame.
7. See Figure 6-114. Disconnect connector [161B] (2) from
actuator.
2
2.38 INTAKE
MAINTENANCE.
NOTE
For actuator or actuator cable replacement see
ACTIVE EXHAUST SYSTEM.
sm00911
1
1. ECM connector [10]
2. ECM connector [11]
3. Negative battery cable
4. Battery and actuator ground
Figure 6-113. Harness and Cable Routing: Lightning (XB12
Models)
sm00912
3
1. Interactive exhaust cable
2. Actuator connector [161B]
3. Interactive exhaust cable wheel
Figure 6-114. Exhaust Actuator (XB12 Models)
Installation
1. See Figure 6-114. Connect actuator connector [161B] (2)
to actuator.
2. Route harness along channel in airbox under frame and
over main wiring harness.
NOTE
If cable is routed in front of the frame lug it will cause the muffler
valve to stay open not allowing it to work properly.
2009 XB Service: Electrical 6-95
6.17 INTER-
2
4
3
2
1