Checking Cast Rim Runout - Buell 2009 XB Series Service Manual

HOME

CHECKING CAST RIM RUNOUT

GENERAL
PART NUMBER
HD-99500-80 WHEEL TRUING AND BALANCING
STAND
Before installing a new tire, check wheels for lateral and radial
runout.
Rim Lateral Runout
1. See Figure 2-32. Install truing arbor in wheel hub and
place wheel in the WHEEL TRUING AND BALANCING
STAND (Part No. HD-99500-80).
2. Tighten arbor nuts so hub will turn on its bearings.
3. Check rim lateral runout by placing a gauge rod or dial
indicator near the rim bead. Replace wheel if lateral runout
exceeds specification. Refer to
Rim Radial Runout
1. See Figure 2-33. Install truing arbor in wheel hub and
place wheel in the WHEEL TRUING AND BALANCING
STAND (Part No. HD-99500-80).
2. Tighten arbor nuts so hub will turn on its bearings.
3. Check radial runout as shown. Replace wheel if runout
exceeds specification. Refer to
Table 2-22. Wheel Rim Runout
MAXIMUM RUNOUT
Lateral
Radial
TOOL NAME
Table 2-22.
Table 2-22.
IN. MM
0.030 0.76
0.030 0.76
sm00111
1. Wheel truing and balancing stand (HD-99500-80)
2. Lateral runout
3. Gauge rod
Figure 2-32. Checking Cast Rim Lateral Runout
sm03726
1. Wheel truing and balancing stand
2. Radial runout
3. Gauge rod
Figure 2-33. Checking Cast Wheel Radial Runout
2009 XB Service: Chassis 2-39
2.8
1
2
3
1
2
3