Buell 2009 XB Series Service Manual page 267

Table of Contents

Advertisement

HOME
sm04534
Figure 3-4. Throttle cable elbow alignment
13. Tighten the throttle cable jamnuts to 36-40 in-lbs (4-4.5
Nm).
14. Install the ignition coil (1) and coil connection [83] (2) and
tighten fasteners to 120-144 in-lbs (13.6-16.3 Nm).
15. Attach plastic clip (3) securing the coil wire to the throttle
cable bracket.
NOTE
Remove shop towel from entrance of throttle body to verify
proper operation of induction module.
16. Connect fuel line (7).
17. Install throttle body velocity stack with retaining ring.
18. Install air filter base plate. See
ASSEMBLY.
19. Install muffler. See
4.18 EXHAUST
NOTES
Due to the location of the CKP it will be necessary to align
the Torca clamp to verify proper clearance between the
chin fairing and the CKP and Torca clamp.
For 1200 model motorcycles with interactive exhaust
systems see
6.17 INTERACTIVE EXHAUST
20. Install idler pulley. See
21. Install left and right side rider footpeg mount. See
22. Install sprocket cover. See
When installing the left side air scoop it is necessary to verify
that the voltage regulator and alternator wiring harnesses are
not trapped between the air scoop and cylinder head.
23. Install air scoops, right and left sides. See
The connection for fuel pump is just above the pump located
at the rear of the fuel tank on the left side of the vehicle.
24. Connect fuel pump. See
25. Install intake cover. See
26. Connect negative ground cable to battery and tighten
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
4.3 AIR CLEANER
27. Install seat.
28. Remove motorcycle from lift.
SYSTEM.
29. Install chin fairing. See
SYSTEM.
5.7 DRIVE BELT AND IDLER
PULLEY.
2.34 FOOTPEG, HEEL GUARD AND MOUNT: FIRE-
BOLT/LIGHTNING
or
2.35 HEEL GUARD AND FOOTPEG
MOUNTS: ULYSSES
MODELS.
2.36 SPROCKET
NOTE
SCOOPS.
NOTE
4.14 FUEL
2.38 INTAKE
fastener to 72-96 in-lbs (8-11 Nm).
2.50 CHIN
2009 XB Service: Engine 3-13
COVER.
2.49 AIR
PUMP.
COVER.
FAIRING.

Advertisement

Table of Contents
loading

Table of Contents