Rear Turn Signals - Buell 2009 XB Series Service Manual

HOME

REAR TURN SIGNALS

BULBS
1. Remove screws on back of housing to access turn signal
bulbs.
2. Rotate bulb 1/4 turn and remove.
3. Before replacing, apply a light coat of dielectric grease on
the bulb contact terminals.
4. Install screw and tighten to 4.4-4.3 in-lbs (0.5-0.6 Nm).
Connections and Wire Routing
NOTE
To verify correct installation, make note of wire routing and
cable strap locations before removing turn signals.
sm00405
1
2
3
1. Left turn signal
2. Tail lamp
3. Right turn signal
4. Tail lamp ground
Figure 6-52. Rear Turn Signal Connections:
Firebolt/Lightning
6-44 2009 XB Service: Electrical
[19A] [19B]
1 V
1
[19B]
[19A]
2 2 BK
[93A] [93B]
1 1 O/W
2
2 R/Y
[93B]
[93A]
1 BK
1
4
[18A] [18B]
1 1 BN
[18A]
[18B]
BK
2
2
sm00458
1
2
3
1. Left turn signal
2. Tail lamp
3. Right turn signal
Figure 6-53. Rear Turn Signal Connections: Ulysses
FIREBOLT
Removal
1. Remove seat. See 2.51 SEAT.
2. Remove tail frame upper body work. See
TAIL ASSEMBLY AND BODY WORK:
3. See Figure 6-52. Disconnect bullet connectors on turn
signal wires.
4. See Figure 6-54. Remove fastener (6) and lockwasher
(5).
5. Remove turn signal from tail section (7) and license plate
bracket (4).
Installation
1. Insert bullet connectors through license plate bracket (4)
and tail section.
2. Install reflector bracket.
a. Place license plate bracket into position over threads
on turn signal.
b. Be sure tab on turn signal fits into hole in reflector
bracket and tab on reflector bracket fits into hole in
license plate bracket.
3. Attach turn signal using lockwasher and fastener. Tighten
fastener to 25-28 in-lbs (2.8-3.2 Nm).
4. Attach bullet connectors on turn signal wires as shown in
Figure 6-52.
6.16
[19A] [19B]
1 V
1
[19B]
[19A]
BK
2 2
[93A] [93B]
R/Y
1 1
2
2
BK
3
3
O/W
[18A] [18B]
BN
1 1
[18A]
[18B]
BK
2 2
2.39 SUBFRAME
FIREBOLT.