Buell 2009 XB Series Service Manual page 517

HOME
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
9. See Figure 6-65. Check headlight for proper operation. If
operation fails, verify that all steps were performed prop-
erly.
a. Turn ignition key switch to ON.
b. Check headlight LOW beam (3) and HIGH beam (2)
settings.
c. Set headlight to LOW beam. Press passing lamp
switch (1). Headlight should flash HIGH beam for as
long as the switch is pressed.
d. Turn ignition key switch to OFF.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
10. Install seat.
11. Align headlight. See 1.17
2009 XB Service: Electrical 6-57
HEADLAMP.