Disassembly: Lightning/Ulysses; Assembly: Lightning/Ulysses - Buell 2009 XB Series Service Manual

HOME
sm00621
10
1. Horn
2. Horn connectors [122]
3. Horn bracket
4. Horn fastener
5. Headlight connector [38]

DISASSEMBLY: LIGHTNING/ULYSSES

1. See Figure 2-144. Remove rubber boots (1) from rear of
headlight housing.
2. Disconnect wiring harness (5) from headlight bulbs (3)
and remove along with position bulb socket (6).
3. Remove bulb holders (2).
4. Remove headlight bulbs (3) from back of headlight housing
(4).
2-110 2009 XB Service: Chassis
1
8
6
7
Figure 2-143. Headlight and Support Bracket: Ulysses
3
4
2
7
6. Screws (2), upper headlight mounting
7. Headlight assembly
8. Screws (2), headlight support bracket
9. Headlight support bracket
10. Left and right front modules

ASSEMBLY: LIGHTNING/ULYSSES

1. See Figure 2-144. Align and install headlight bulbs (3) into
back of headlight housing (4).
The tab on the base of the headlight bulb should rest between
the two tabs located at the top of the hole on the back of the
headlight assembly.
2. Install bulb holders (2).
3. Connect wiring harness (5) to headlight bulbs (3) and
install rubber boots (1) and install position bulb socket (6)
between the headlights. For alignment of rubber boots,
see 6.18 HEADLIGHT.
5
8
10
9
6
NOTE