Installation - Buell 2009 XB Series Service Manual

HOME
3. Using a Snap-on seal and bushing driver, tap in the
bearing.

INSTALLATION

1. See Figure 2-204. Apply LOCTITE 271 (red) to LH and
RH grab handle fasteners (1, 3, 11, 12).
2. Install the LH grab handle (13) unto the front fastener and
install the rear fastener. Do not tighten.
3. Slide the spring (6) into the LH grab handle (13).
4. Press the spring with the shaft of the triple tail rack and
hold the rack in place capturing the spring.
5. Install the plastic collar (10) and tighten the fastener to
36-48 in-lbs (4.0-5.4 Nm).
sm00693
5
4
2
1
1. Front fastener, grab handle
2. RH grab handle
3. Rear fastener with washer, grab handle
4. Bearing (2)
5. Tail rack
6. Spring
7. Pin
Figure 2-204. Triple Tail, Passenger Backrest and Luggage Rack: Ulysses
2-168 2009 XB Service: Chassis
4
3
14
6. Holding the rack, fit the RH grab handle (2) unto the front
fastener and install the rear fastener. Do not tighten.
7. Tighten front and rear fasteners to the following specifica-
tions:
a. Tighten rear fasteners (3, 11) to 23-25 ft-lbs (31-34
Nm).
b. Tighten front fasteners (1, 12) to 108-120 in-lbs (12-
13.5 Nm).
8. Verify that the rack operates properly.
9. Install the plastic wire cover under the license plate lamp.
Tighten the screws to 36-48 in-lbs (4.0-5.4 Nm) and
tighten the nuts to 12-36 in-lbs (1.4-4 Nm).
10
9
8
6
11
7
8. Detent, tail rack
9. Screw, collar
10. Collar, tail rack
11. Rear fastener with washer, grab handle
12. Front fastener, grab handle
13. LH grab handle
14. Tail loop
13
12