Buell 2009 XB Series Service Manual page 681

PART NUMBER
HD-34902-7 END CAP
HD-34902-7 END CAP
HD-34902B BEARING RACE REMOVER/INSTALLER
HD-34902B BEARING RACE REMOVER/INSTALLER
HD-35102 WRIST PIN BUSHING HONE
HD-35316-11 RECEIVER CUP
HD-35316-12 INSTALLER CUP
HD-35316-4A 8 IN. BOLT
HD-35316-4A 8 IN. BOLT
HD-35316-4A 8 IN. BOLT
HD-35316-7 WASHER
HD-35316-7 WASHER
HD-35316-8 BEARING DRIVER
HD-35316-9 BEARING DRIVER
HD-35457 BLACK LIGHT LEAK DETECTOR
HD-35667A CYLINDER LEAKDOWN TESTER
HD-35758-C NEWAY VALVE SEAT CUTTER SET
HD-38125-6 PACKARD TERMINAL CRIMP TOOL
HD-38125-7 PACKARD TERMINAL CRIMPER
HD-38125-7 PACKARD TERMINAL CRIMPER
HD-38125-8 PACKARD CRIMPING TOOL
HD-38125-8 PACKARD CRIMPING TOOL
HD-38362 FOR XB9 SPROCKET LOCKING LINK
MODELS
HD-38362 FOR XB9 SPROCKET LOCKING LINK
MODELS
HD-38515-91 CLUTCH SPRING FORCING SCREW
HD-38515-A SPRING COMPRESSING TOOL
HD-39302 STEERING HEAD BEARING RACE
INSTALLER
HD-39302 STEERING HEAD BEARING RACE
INSTALLER
HD-39786 CYLINDER HEAD HOLDING FIXTURE
HD-39965-A DEUTSCH TERMINAL CRIMP TOOL
HD-39969 ULTRA TORCH UT-100
HD-41177 FORK HOLDING TOOL
HD-41182 FUEL PRESSURE GAUGE
Tools Used in This Manual
TOOL NAME NOTES
3.18 CRANKCASE, Piston Jets
3.18 CRANKCASE, Pinion Shaft Bearing
3.18 CRANKCASE, Piston Jets
3.18 CRANKCASE, Pinion Shaft Bearing
3.8 CYLINDER AND PISTON, Connecting Rod Bushing
5.12 MAIN DRIVE GEAR AND BEARING, Removal
5.12 MAIN DRIVE GEAR AND BEARING, Installation
5.12 MAIN DRIVE GEAR AND BEARING, Removal
5.12 MAIN DRIVE GEAR AND BEARING, Installation
5.12 MAIN DRIVE GEAR AND BEARING, Installation
5.12 MAIN DRIVE GEAR AND BEARING, Removal
5.12 MAIN DRIVE GEAR AND BEARING, Installation
5.12 MAIN DRIVE GEAR AND BEARING, Installation
5.12 MAIN DRIVE GEAR AND BEARING, Removal
1.20 TROUBLESHOOTING, Lubrication System
3.3 ENGINE, Cylinder Leakage Test
3.7 CYLINDER HEAD, Procedure For Using The Neway
Valve Seat Cutter
A.13 PACKARD METRI-PACK TERMINALS, Metri-Pack
Terminal Crimps
A.7 DEUTSCH MINI TERMINAL REPAIR, Deutsch Mini
Terminal Crimps
A.13 PACKARD METRI-PACK TERMINALS, Metri-Pack
Terminal Crimps
A.13 PACKARD METRI-PACK TERMINALS, Metri-Pack
Terminal Crimps
A.16 SEALED SPLICE CONNECTORS, Sealed Splice
Connector Repair
5.6 PRIMARY CHAIN, Removal
5.6 PRIMARY CHAIN, Installation
5.5 CLUTCH, Removal
5.5 CLUTCH, Removal
2.6 REAR WHEEL, Assembly
2.18 STEERING HEAD BEARINGS, Installation
3.7 CYLINDER HEAD, Procedure For Using The Neway
Valve Seat Cutter
A.5 DEUTSCH STANDARD TERMINAL REPAIR, Deutsch
Standard Terminal Crimps
A.16 SEALED SPLICE CONNECTORS, Sealed Splice
Connector Repair
2.16 FRONT FORKS: ALL MODELS, Disassembly
4.16 FUEL PRESSURE TEST, Inspection
TOOLS III