Buell 2009 XB Series Service Manual page 670

HOME
sm03609
1. Cable stop screw
2. Active cable wheel
REMOVAL
NOTE
If solenoid bracket needs to be replaced, remove the baseplate
assembly, turn it over and remove the three fasteners securing
the bracket to the baseplate.
1. See Figure E-4. Disconnect electrical connector [178] (1).
2. Hold solenoid shaft by flat spot provided and break cable
connector (6) loose.
E-4 2009 XB Service: Appendix E Active Intake (Japanese Models)
1
Figure E-3. Active Intake Cable Stop Screw
3.
4.
Follow next step only is solenoid is to be replaced.
5.
1
2
Unthread cable connector and disconnect cable from
solenoid (8).
Loosen jam nut (5) and disconnect active cable (2) from
cable bracket (4).
NOTE
Loosen pinch fastener on solenoid bracket (9).