Buell 2009 XB Series Service Manual page 220

HOME
sm04798
10
11
12
1. Main harness
2. Electronic control module
3. ECM connectors [10] and [11]
4. Fuse block and relay center
5. Main harness ground wire [GRD2]
6. Main harness with plastic grommet
7. Battery ground cable
Figure 2-171. Main Harness and Electrical Components Under Seat: Ulysses
ASSEMBLY
1. See Figure 2-171. Install trunk pan assembly (13) from
left side of vehicle.
2. Install fastener securing right front trunk pan to right side
tail section and tighten to 12-36 in-lbs (1.4-4 Nm).
3. Install shock reservoir, retainer and fastener. Tighten
fastener to 80-88 in-lbs (9.0-9.9 Nm).
4. Install left tail section (14) onto vehicle.
a. Apply LOCTITE 271 (red) and install fasteners
attaching left tail section to main frame/fuel tank
assembly and tighten to 21-23 ft-lbs (28.5-31.2 Nm).
b. Install fastener attaching left front trunk pan to left
side tail section and tighten to 12-36 in-lbs (1.4-4
Nm).
5. Install two fasteners securing the preload adjuster to the
trunk pan and tighten to 36-60 in-lbs (4-7 Nm).
2-142 2009 XB Service: Chassis
14
6
7
9
13
9
8
4
5
3
2
8. Battery positive cable
9. Left rear and right rear tail section fasteners (4)
10. Seat lock cable
11. Bank angle sensor (BAS) connector [134]
12. Auxiliary power outlet
13. Trunk pan
14. Left tail section
6. Install battery pan:
a. Install fasteners securing battery tray to left and right
tail sections and tighten to 72-96 in-lbs (8-11 Nm).
b. Install fuse block and relay center (5).
c. Install main harness and plastic grommet (7) into
battery pan.
d. Install bank angle sensor (2), connect and tighten
fastener to 12-36 in-lbs (1.4-4 Nm).
e. Connect rear brake light switch connector [121].
f. Install ECM and tighten fasteners to 36-60 in-lbs (4-
7 Nm).
7. See Figure 2-171. Connect ECM connectors (4) [10], [11]
and [164].
8. Install center tail loop. See
ULYSSES MODELS.
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
9. Install battery. See 1.5 BATTERY
1
2.44 CENTER TAIL LOOP:
MAINTENANCE.