Installation - Buell 2009 XB Series Service Manual

HOME
sm05260
3
2
1
1. Sidestand spring
2. Spring extension plate
3. Pivot pin
4. Spring post
5. Sidestand bracket
6. Sidestand bracket fasteners (3)
7. Pivot pin circlip
8. Tab, sidestand switch (HDI)
9. Sidestand leg
Figure 2-179. Sidestand Assembly: Ulysses Models
ASSEMBLY
PART NUMBER
HE-52B SNAP-ON SPRING TOOL
1. See Figure 2-179. Install sidestand leg (9).
2. Lubricate sidestand pivot pin and mating portions on
sidestand bracket with WHEEL BEARING GREASE (Part
No. 99855-89) as shown in
3. See Figure 2-179. Install sidestand leg (9) to bracket (5)
by installing the pivot pin (3) and pivot pin circlip (7).
2-150 2009 XB Service: Chassis
5
4
6
7
8
9
TOOL NAME
Figure 2-180.
4. Retract sidestand leg (9).
5. Install spring extension plate (2) and sidestand spring (1)
using SNAP-ON SPRING TOOL (Part No. HE-52B).
6. Extension plate should curve away from primary chain
adjustment screw to allow for clearance around adjustment
screw.

INSTALLATION

1. See Figure 2-179. Apply LOCTITE 271 (red) to the
sidestand bracket fasteners (6). Loosely install the
sidestand assembly to the crankcase with the sidestand
bracket fasteners (6). Extend the sidestand leg (9) and
hold forward in the fully extended position while tightening
the sidestand bracket fasteners in the following sequence:
a. Tighten the front fastener(s) to 25-27 ft-lbs (34-37
Nm).
b. Tighten the rear fastener to 25-27 ft-lbs (34-37 Nm).
2. Repeat the tightening sequence in the previous step to
verify proper clamp load.
3. Install muffler. See 4.18 EXHAUST SYSTEM, Assembly
and Installation.
4. Install chin fairing fasteners. See
5. Extend and retract sidestand leg to check for proper
operation.
sm00129
Figure 2-180. Sidestand Assembly Lubrication (Shaded
Areas) (Typical)
2.50 CHIN FAIRING.