Table of Contents
Advertisement
HOME
Disconnect:
a.
Ignition switch [33] (6).
b.
Turn signal flasher connector [30] (1).
c.
Instrument module connector [39] (2).
d.
Left handlebar connector [24] (4) and right handlebar
connector [22] (3).
e.
Turn signal connectors [31] (5).
f.
Headlight connector [38].
g.
Horn connector [122] (11).
h.
Clutch switch [95] from left switch housing.
i.
Front brake switch [121] from right switch housing.
14. Firebolt: See
Figure
6-104. Disconnect:
a.
Flasher connector [30].
b.
Bank angle sensor connector [134].
c.
Electronic control module (ECM). See
TRONIC CONTROL MODULE
d.
Instrument module connector [39].
e.
Horn connectors [122].
f.
Ground terminals on front of steering head.
g.
Left switch housing connector [24] and right switch
housing connector [22].
h.
Clutch switch [95] from left switch housing.
i.
Front brake switch [121] from right switch housing.
j.
Headlight connector [38].
k.
Ignition switch [33].
15. Cut and remove cable strap (7) securing main harness (8)
to ignition switch.
16. Remove ground terminals on front of steering head.
17. Remove wire harness guide from steering neck.
18. Remove all tree fasteners from frame.
19. Disconnect wiring located under sprocket cover. See
6.30 SPROCKET COVER
4.4 ELEC-
(ECM).
WIRING.
20. Remove connector from oil pressure switch [120]. See
3.14 OIL PRESSURE INDICATOR
21. Disconnect:
a.
Intake air temperature sensor [89].
b.
Throttle position sensor [88].
c.
O2 sensor [137].
d.
Temperature sensor [90].
e.
Fuel injectors [84] & [85].
f.
Fuel pump connector [86].
g.
Idle air control [87].
22. Disconnect and remove ignition coil.
NOTE
When removing the left air scoop, the alternator and voltage
regulator harnesses and connections are secured to the bottom
of the air scoop with three cable straps.
23. Remove left side air scoop. See
24. Disconnect alternator connector [46] (1) and voltage regu-
lator connector [77] (2).
25. Remove the two cable straps securing the CKP harness
to the "V" bracket on the left side of the engine and discon-
nect CKP.
NOTES
It will be necessary to remove fastener securing rear har-
ness guide to underside of frame.
On Firebolt models it will be necessary to remove fastener
securing harness clamp to fairing support bracket.
26. Remove any remaining cable straps and clamps securing
wire harness and remove harness from rear of vehicle.
27. Pull the main harness out through the rear of the frame/fuel
tank assembly between the trunk pan and the rear tire.
NOTE
Using scissors jack, raise vehicle higher to gain more clearance
between the trunk pan and tire.
28. Remove all tree fasteners.
2009 XB Service: Electrical 6-79
SWITCH.
2.49 AIR
SCOOPS.
Advertisement
Chapters
Table of Contents
