Buell 2009 XB Series Service Manual page 471

HOME
sm00473
11
1. Turn signal flasher connector [30]
2. Instrument cluster connector [39]
3. Right handlebar connector [22]
4. Left handlebar connector [24]
5. Turn signal connectors [31]
6. Ignition switch [33]
7. See Figure 6-8. Use SNAP-ON TAMPER RESISTANT
T45 TORX DRIVER (Part No. FTXR45E) to remove the
two tamper-resistant Torx fasteners (2) securing ignition
switch to upper fork clamp.
8. Remove the final ignition switch fastener (1) along with
spacer located behind the ignition switch.
1
3
10
Figure 6-7. Electrical Connectors Behind Windscreen: Lightning
2
5
8
9
7. Main harness
8. Horn fastener
9. Horn mount
10. Horn connector [122]
11. Horn
9. While holding the throttle cables (3) to your left (the right
side of the vehicle), pull the ignition switch (4) toward you
and roll the assembly away from you until the fork stop
pin (5) is pointing down.
10. Slide the ignition switch assembly out to your left (the right
side of the vehicle).
2009 XB Service: Electrical 6-11
4
5
6
7