Storage - Buell 2009 XB Series Service Manual

HOME
3. Insert fastener through battery positive cable (red) into
threaded hole of battery positive (+) terminal and tighten
fastener to 72-96 in-lbs (8-11 Nm).
4. Install terminal cover boot.
5. Insert fastener through battery negative cable (black) into
threaded hole of battery negative (-) terminal and tighten
fastener to 72-96 in-lbs (8-11 Nm).
6. Apply a light coat of petroleum jelly or corrosion retardant
material to both battery terminals.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
7. Install seat.

STORAGE

PART NUMBER
94654-98 SUPERSMART BATTERY TENDER
Batteries contain sulfuric acid, which could cause severe
burns to eyes and skin. Wear a protective face shield,
rubberized gloves and protective clothing when working
with batteries. KEEP BATTERIES AWAY FROM CHILDREN.
(00063a)
Do not allow battery to completely discharge.The electro-
lyte in a discharged battery will freeze. The more dis-
charged a battery is, the more easily it can freeze and crack
the battery case. (00218a)
If the motorcycle will not be operated for several months, such
as during the winter season, remove the battery from the
motorcycle and fully charge.
1-14 2009 XB Service: Maintenance
TOOL NAME
See Figure 1-3. Self-discharge is a normal condition and occurs
continuously at a rate that depends on the ambient temperature
and the battery's state of charge. Batteries discharge at a faster
rate at higher ambient temperatures. To reduce the self-dis-
charge rate, store battery in a cool (not freezing), dry place.
Charge the battery every month if stored at temperatures below
60° F (16° C). Charge the battery more frequently if stored in
a warm area above 60° F (16° C).
NOTE
The SUPERSMART BATTERY TENDER (Part No. 94654-98)
may be used to maintain battery charge for extended periods
of time without risk of overcharging or boiling.
When returning a battery to service after storage, fully charge
the battery.
om00036
1
100 %
75 %
3
50%
0 3
1. Capacity
2. Months of non-use
3. Measured at 105° F (40° C)
4. Measured at 77° F (25° C)
Figure 1-3. Effective Rate of Temperature on Battery
Self-discharging Rate
4
6 9 12 15
2