Adjust The Image To Fit Your Screen - Christie CP2215 Quick Start Manual

2. Tap Menu > Advanced Setup > LampLOC Setup.
3. Tap Display Full Screen White Test Pattern.
4. Tap Do Auto.

Adjust the Image to Fit Your Screen

This procedure must be completed before you complete a boresight adjustment.
1. Verify the projector is properly positioned relative to the screen.
See Position the Projector
2. Display a RGB-12bit-Full Screen White test pattern and center the image:
a. Tap the Test Pattern icon (
b. Tap All Test Patterns.
c. Tap RGB-12bit-Full Screen White.
d. On the projector touch panel controller (TPC), tap the Lens Adjust (
main screen and then tap the left (
in the Offset area until the light created by the projector is centered on the screen.
3. Display the DC2K Framing2 test pattern:
a. On the projector TPC, tap the Test Pattern (
b. Tap All Test Patterns.
c. Tap DC2K Framing2.
4. On the projector TPC, tap the Lens Adjust (
( ), right (
of the test pattern on the screen.
5. In the Zoom area, tap the positive (
screen.
6. In the Focus area, tap the left (
are in focus.
When your adjustment is complete, the words and lines in the test pattern should be
distinguishable uniformly across the screen and there should not be any sections that are out of
focus.
7. With the framing test pattern displayed, re-check projector leveling so the top edge of the
image is parallel to the top edge of the screen.
CP2215 Quick Start Guide
020-101295-01 Rev. 1 (11-2013)
on page 4.
), up ( ), or down (
) and right (
) in the task bar.
), right ( ), up (
) icon in the task bar.
) icon on the main screen, and tap the left
) arrow icons in the Offset area to refine the position
) and minus ( ) icons until the image fits your
) focus icons until the test pattern details
Installation and Setup
) icon on the
), or down ( ) arrow icons
18