Disconnect All But One Laser Modules; Image Adjustments Performed With Low White Light; Orient The Screen Image; Calibrate The Lens Motors - Christie D4KLH60 Mirage 4KLH Installation Manual

Disconnect all but one laser modules

Initial image adjustments require low power from a single laser module.
1. Under Connected Modules, select the IP address of a laser module you want to disconnect.
2. Click Disconnect.
3. Repeat steps 1 to 2 until there is only one laser module connected.
Image adjustments performed with low white
light
Make image adjustments with low light levels from a single laser module. Failure to comply
could result in minor or moderate injury.
The image adjustments described in this section are done with low light from a single laser module.

Orient the screen image

1. To display the a white test pattern, on the Home tab in the Pattern list, select Flat White.
2. Tap Menu > Configuration > Image Orientation.
3. Select the orientation you want from the list.

Calibrate the lens motors

1. On the TPC screen, tap Lens> Calibrate Lens.

Adjust the image to fit the screen

1. Center the image on the screen.
a. On the TPC, tap the Lens tab.
b. Tap the left, right, up, and down arrows until the image is centered on the screen.
2. To display the DC2K Framing2 test pattern, on the Home tab in the Pattern list, select DC2K
Framing2.
3. To adjust the position of the test pattern, repeat step 1.
4. Under Zoom, tap the magnifying glasses until the image fits the screen.
5. Under Focus, tap the left and right arrows until the test pattern details are in focus.
The words and lines on the test pattern should be distinguishable uniformly across the screen.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Adjust the Image
53