Removing structural components and frame
Before carrying out dimensional checks on the frame, remove all the fitted superstructures, referring to the
removal procedures outlined in the relevant sections of this manual.
The list below indicates the components to be removed in a logical order.
Remove the seat
(Removing the
Remove the fuel tank
Remove the air filter
Remove the throttle control cable
Remove the airbox
(Removing the
Remove the throttle body, the blow by and the oil breather pipe
Remove the secondary air system pipes and valve
Remove the supply system and the injectors from the intake manifolds
Disconnect the spark plug caps.
Remove the exhaust system
Drain the lubrication system
Disconnect the starter motor/solenoid starter cable.
Remove the gear shift
Remove the front sprocket
Remove the side stand
Disconnect the wiring connectors on the engine block (Routing of wiring on frame).
Remove the engine block from frame.
seat).
(Removing the fuel
tank).
(Removing the air
filters).
(Removing the throttle
airbox).
(Removing the exhaust
(Changing the engine oil and filter
(Removing the gear
shift).
(Removing the front
(Removing the side
stand).
control).
(Removing the throttle
(Removing the secondary air
system).
cartridge).
sprocket).
body).
system).
(Removing the throttle
body).