Table of Contents
Advertisement
steering shaft after heating it for about 10 minutes to 120 °C.
Insert drift no. 88713.1072. Push the inner ring (7) on dust seal (8), manually pushing for at least 10-
15 seconds.
Lubricate the inner ring (7) with the recommended grease. Fit the ball race (6) on the steering shaft with
the smaller diameter of the cage facing upwards, and grease the ball race.
Fit the bottom yoke assembly to frame.
Fit the internal ring (3), the ball race (4) and the external ring (2).
Advertisement
Table of Contents
