Refitting the flywheel/generator assembly
If previously disassembled, reassemble the flywheel following the indications described below.
Fit starter clutch (27) on flywheel (23).
Bring the starter clutch edge (B) fully home on the flywheel.
Position flange (28) on the flywheel and start screws (24).
Tighten screws (24).
Position rotor (26) on flywheel (23).
Apply the indicated threadlocker and start screws (22).
Tighten screws (22) respecting the indicated sequence to a torque of 13 Nm (Min 11 Nm Max 15 Nm).