Table of Contents
Advertisement
Refitting the exhaust system
Check the presence of the two clips (13) on the exhaust manifold.
Tighten plug (14) with relevant seal to a torque of 25 Nm ± 10%.
Start the lambda sensor and tighten it to a torque of 45 Nm ± 10%.
Fit the heat reflective material (15) in heat guard (16).
Position the two washers (17) on heat guard (16), apply indicated threadlocker and insert the two retaining
screws (18) and tighten them to a torque of 8 Nm ± 10%.
Advertisement
Table of Contents
