Before fitting new bearings, check that the seat is clean and free from scoring and damage.
Grease the bearing seat and then push the new bearing into its seat.
Using a tubular drift (D) that only bears on the outer ring of the bearing (10) to drive the latter fully into its
seat.
Use the same method to install the sealing rings (9).
Ensure that spacer (8) is fitted between the two wheel hub bearings.
Note
Wheels must be rebalanced after repair, maintenance and overhaul operations.
Inspecting the wheel shaft
For the check values refer to paragraph
(Front
Wheel).
Check the wheel shaft (7) for straightness. Turn the shaft on a reference surface and measure maximum
distortion using a feeler gauge.