Table of Contents
Advertisement
Refitting the lubrication system
Important
The gasket must be positioned with the sharp edge facing the cooler.
Start nipples (9) on oil cooler with gasket (10) and tighten them to 23 Nm ± 10%.
Tighten nuts (8) to a torque of 25 Nm ± 5% to fasten pipes (6) and (7).
Position the oil cooler (5) and fix it by means of the two screws (4).
Tighten the two screws (4) to a torque of 10 Nm ± 10%.
Tighten the two nuts (1) and (2) to a torque of ± 18 Nm 5%.
Tighten nut (3) on the oil pressure switch to a torque of 18 Nm ± 5%.
Advertisement
Table of Contents
