Table of Contents
Advertisement
Checking and overhauling the components
Clearance between the clutch housing and friction plate
Insert a friction plate (E) in the clutch housing (F) and measure the clearance (S) with a feeler gauge.
Clearance "S" must not exceed 0.6 mm.
If it does, replace the plates and, if necessary, the clutch housing.
Overhauling the clutch plates
The clutch plates must not show any signs of blackening, grooves or deformation.
Measure the thickness of the friction plates; it should not be less than 2.6 mm.
Important
The total thickness of the plates pack must not be less than 46.1 mm.
Place the plate on a flat surface and check the amount of deformation with a feeler gauge.
Max. flatness error: 0.2 mm.
Advertisement
Table of Contents
