Table of Contents
Advertisement
Reassembling the gearbox shafts
Reassemble the gears on the gearbox shafts by reversing the disassembly procedure.
Take particular care when installing the idler gears.
The assembly of the 3rd and 4th speed gears and the relative fixing components on the secondary shaft is
given as an example.
Fit the snap ring (17), checking that it is fully inserted into its groove on the shaft.
Push the snap ring into position with a suitable size tubular drift.
Slide the three-pointed washer (18) over the shaft until it locates against the snap ring you have just fitted.
To fit the roller bearing cage (21) onto the shaft, first lubricate it with plenty of grease (of recommended
type) and then open it slightly to make it easier to slide on to the shaft.
Fit the 3rd speed gear (22).
Advertisement
Table of Contents
