Table of Contents
Advertisement
Remove the tool and check that pin (28) on the gearbox drum is aligned with notch (29) on the gearchange
pawl.
With the gearbox in neutral, check that the lever travel is the same when shifting up and down.
The same should apply when a gear is engaged.
Operate the gearchange lever and turn the front sprocket at the same time to check that all the gears
engage when shifting up and down.
Remove the gearchange lever.
Reassembling the gearchange mechanism
If during the removal procedure the gearchange mechanism has been removed, it is necessary to engage
the spring (10) on shaft (12) in the position indicated in the picture.
Use the specified product to grease the threaded end of the eccentric pin (12) and fit it from the upper side
of the gearchange lever and fix it with nut (13).
Screw the nut fully home (without tightening).
Advertisement
Table of Contents
