Abs Control Unit Enabling/Disabling - Ducati SCRAMBLER 800 Workshop Manual

ABS control unit enabling/disabling

This function allows enabling or disabling the ABS system. Enter the SETTING MENU.
Select the parameter to be customised (ABS), by pressing button (1) or (2). Once the desired parameter is
highlighted, press CONFIRM MENU button (4).
When entering the function, the currently set ABS status will be displayed:
On = enabled, Off = disabled.
Menu indicates the available alternative option (RQ):
RQ OFF when current status is "On", RQ ON when current status is "Off".
To quit the function without changing set status, select EXIT using button (2); when its box is flashing,
press button (4).
To select a different status than the one set, press button (1); alternative option (RQ) starts flashing in the
Menu.
Press button (4) for 3 seconds to confirm. WAIT is displayed in the Menu for approx. 5 seconds. New status
will then become steady on and "EXIT" box will be flashing.
Press button (4) to quit the function.
Note
By setting "–" (Off), the ABS will be disabled and the relevant warning light will start flashing.
Important
When setting the ABS OFF, Ducati recommends paying particular attention to the braking and riding style.
If the ABS is in fault, "Err" is displayed when entering the function and Menu will indicate "NO RQ", since no
selection is actually possible. "EXIT" box is flashing. Press button (4) for 3 seconds to quit the function.