Table of Contents
Advertisement
Changing the front phonic wheel sensor
REMOVAL PROCEDURE
Disconnect front ABS sensor (2) connector (1) from main wiring.
Open all clips retaining front ABS sensor cable (1): refer to tables under Section:
hoses".
Undo the retaining screw (3), and remove front ABS sensor (2) with calibrated gasket (4), sliding cable out
from cable grommet.
REFITTING PROCEDURE
Before refitting, make sure that contact parts between front ABS sensor (2) and its seat are free of damage
and perfectly clean. Fit the new front ABS sensor (2) on its seat inserting the screw (3). Check air gap
between front ABS sensor (2) and front phonic wheel as explained under Section
phonic wheel
sensor".
Tighten screw (3) to a torque of 7 Nm ±10%.
"Routing wiring harnesses /
"Adjusting the AIR-GAP of
Advertisement
Table of Contents
