Table of Contents
Advertisement
Bring the crankcase halves (44) and (45) together, tapping with a rubber mallet in the area of the shafts if
necessary.
Start screws (3), (4) and (5) on the generator-side crankcase half, paying attention to the different lengths.
Start and progressively drive fully home the jointing screws starting with those with a larger diameter (M8).
Install two M8 screws (3) on the clutch side crankcase half.
Tighten all screws to the indicated torque:
- screws (8) first to a snug torque of 19 Nm (Min. 17 Nm - Max. 21 Nm), then to a tightening torque of 25
Nm (Min. 22 Nm - Max. 28 Nm);
- screws (4) and (5) to a torque of 10 Nm (Min. 9 Nm - Max. 11 Nm).
Advertisement
Table of Contents
