Table of Contents
Advertisement
Refitting the valves and rocker arms
To refit them follow the removal reverse procedure, paying attention to the operations that are specifically
indicated.
It is extremely important to thoroughly clean all components.
If seal rings (17) of the valve guides have been removed, fit new ones after lubricating them with engine oil
and fit them on the side with spring on tool no. 88713.2442.
Fit the end of the tool into the valve guide and use a hammer to tap the sealing rings (17) home into the
valve guides.
Refitting rocker arms, shims and valves
Closing rocker arm
Fit on tool (A) no. 88713.2783 the closing rocker arm (10) and the relevant spring (15).
Fit the tool-rocker arm-head spring assembly and shaft (14) with a new lubricated seal.
Advertisement
Table of Contents
