Table of Contents
Advertisement
In case of axial runout, tension the spokes on the side featuring a value increase and loosen those on the
opposite side. Always work on several spokes, at least on two spokes per side, by letting them perform
small rotations between one check and the following one.
In case of radial runout, loosen the rim spokes featuring a value increase and tension those on the opposite
side. Check the axial runout again as described above.
Loosen the wheel pack, invert its installation sense and tighten it to check the axial and radial runout and
camber on the other side:
fix the axial runout reference to check the correct camber: symmetric for the front wheel and ensured
-
by the suitable spacers for the rear wheel;
fix the radial runout reference to check the rim shoulder that has not been checked before.
-
Repeat the checks and operate until reaching the specified value of 0.8 mm.
Tighten nipples (11) to a minimum torque of 4 Nm.
Advertisement
Table of Contents
