Table of Contents
Advertisement
Apply the recommended threadlocker to screw (12).
(12) TCEIF M6X45 screw
Insert screw (12) with elastic washer (G) and washer (H) from the outside of the number plate holder.
Insert bushing (I) from inside the number plate holder.
Position the number plate holder subframe on the swinging arm by starting the screw by hand without
tightening to torque.
Tighten the screws in the indicated sequence below.
Tighten the two screws (8) to a torque of 25 Nm ± 10%.
-
Tighten the screw (12) to a torque of 18 Nm ± 10%.
-
Tighten the screw (11) to a torque of 30 Nm ± 10%.
-
Tighten the screw (18) to a torque of 30 Nm ± 10%.
-
Tighten all five screws again following the sequence above.
-
Fit screws (5) with cable ring and tighten them to a torque of 1.5 Nm ± 10%.
Reposition the self-locking tie (7).
Advertisement
Table of Contents
