Table of Contents
Advertisement
Put the spacer of tool no. 88713.2878 between the con-rods and take up residual axial clearance with the
fork feeler gauge of tool no. 88713.2878 which has shims of the following sizes: - 0.1 mm - 0.2 mm - 0.3
mm.
Using a torque wrench as shown in the figure, tighten screws (3) to the values specified here below:
- tighten to 35 Nm;
- pause of 2 seconds and 360° loosening;
- pre-tighten again to 20 Nm;
- pre-tighten again to 35 Nm;
- tighten to 65 ±1
- torque check 70÷103 Nm.
Remove the feeler gauge and check that connecting rods/crankshaft end float is: 0.15÷0.35 mm.
Advertisement
Table of Contents
