Table of Contents
Advertisement
Wash the pins and dry them with compressed air.
Clean and use engine oil to lubricate the crank pin and the bearing shells and refit the con-rods on the
crankshaft, in the position they were when they were removed.
Fit the cap and the relevant con-rod with the mark on the same side.
Fill the recommended grease into the two ends of the hole to lubricate threads and underside of the new
screws (3) and the thread of the shaft.
Warning
The grease utilised is irritant in contact with the skin; wear protective gloves.
Important
Lubrication of con-rod bolts is essential to obtain the correct coupling and to prevent breakage of the parts.
The con-rod screws may only be used for one tightening.
Temporarily fit the gudgeon pin (9) to align the connecting rods.
Advertisement
Table of Contents
