Table of Contents
Advertisement
Route the number plate light wiring in the number plate holder subframe.
Tighten the three screws (13) with relevant cable plate to a torque of 2 Nm ± 10%.
Important
Thoroughly remove the threadlocker from the swinging arm threads and the subframe/number plate holder
mating surfaces.
Apply the specified threadlocker to screws (11) and (18).
(11) TCEIF M8X35 screw
(18) TCEIF M8X35 screw
Insert screw (18) with elastic washer (E) and short washer (D) from the outside of the number plate holder
subframe.
Insert bushing (F) from inside the frame.
Insert screw (11) with elastic washer (E) and long washer (C) from the outside of the number plate holder
subframe.
Insert bushing (F) from inside the frame.
Advertisement
Table of Contents
