Clock Setting Function (Clock) - Ducati SCRAMBLER 800 Workshop Manual

Clock setting function (CLOCK)

This function allows setting the clock.
To view this function, enter the Setting Menu, use button (1) or (2) to select CLOCK and press button (4).
To access the setting function, keep button (2) pressed for 3 seconds.
After 3 seconds it is possible to set the clock as follows:
the "AM" indication starts flashing;
-
if you press button (2) the "PM" indication starts flashing;
-
if you press button (1) you will return to the previous step (if it is 00:00, when switching between
-
"AM" to "PM", 12:00 will be displayed);
press button (4) to shift to hour setting, hours will start flashing;
-
each time you press button (2), the digit will increase by one hour. If you hold button (2) down,
-
the number increases cyclically in steps of one hour every second (when the button is held
depressed, the hours do not flash);
pressing button (4) gives access to the minute setting mode; minutes start to flash;
-
each time you press button (2), the digit will increase by 1 minute. If you hold button (2) pressed,
-
the count increases cyclically in steps of 1 minute every second;
if button (2) is kept pressed for more than 5 seconds, steps increase in steps of 1 every 100 ms
-
(seconds will not flash while button (2) is pressed).
To confirm (store) the new set time press button (4).
The EXIT box starts flashing, press button (4) to go back to the setting menu.
Note
In case of battery off, when the Voltage is restored and upon next Key-On, clock will have to be set again,
i.e. it will automatically start counting from 00:00.
To quit, press button (4).