4.3 Stacking multiple projectors
WARNING: G100 projectors can be stacked up on top of each other on a flat surface, or suspended
from a truss using the rigging frame. But keep the following in mind:
It is allowed to stack maximum three projectors
It is allowed to suspend maximum two projectors
For illustration purposes, the images display the UDX projector. This procedure is identical for the
G100 series projectors.
How to stack
1.
Make sure that each projector is installed in their respective rigging frame.
2.
If pre-installed, remove all four locking pins (reference 1,
frame that will be installed on top of the stack.
Image 4–9
1
Locking pin
Note: Even if not all pins are necessary in your current setup, it is important to keep all locking
pins to their respective rigging frame for future use.
3.
Stack the frames. Make sure the stacking pins of both frames are aligned.
Image 4–10
2
Lower stacking pins
3
Upper stacking pins
4.
Install a locking pin (reference 1,
Image
Image
4–11) through the overlapping hole of both stacking pins.
Rigging frame
4–9) from each rigging frame, except the
1
R5913458 /01
G100
55