Fig 6-2 Pulley 2, Tension Spring, Sensor And Ground Wire; Rrp 6-2 Horizontal Transport Pulley 2, Tension Spring, In-Gate Sensor And Ground Wire (Pl 20.2) - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RRP 6-2 Horizontal Transport Pulley 2, Tension
Spring, In-Gate Sensor and Ground Wire (PL 20.2)

Fig 6-2 Pulley 2, Tension Spring, Sensor and Ground Wire

Removal
1. Remove the
Horizontal Transport Rear Cover
2. Unhook the Tension Spring from the hole in the Horizontal Transport frame.
3.
Remove two screws that secure the Tension Bracket Assembly (PL 20.2.11) to
the Horizontal Transport, and remove the bracket together with the spring.
4.
Unplug the connector (P/J260) of the Horizontal Transport Harness Assembly
(PL 20.2.24) from the Sensor.
5.
Unclip the Sensor at three places, and remove the In-Gate Sensor (PL
20.2.17).
6.
Remove two screws that secure the ground wire to the Horizontal Transport,
and remove the wire.
Replacement
1.
Secure the ground wire to the Horizontal Transport with two screws.
2.
Align the In-Gate Sensor with the mounting position in the Horizontal Transport,
and push in to secure.
3.
Plug the connector (P/J260) of the Horizontal Transport Harness Assembly (PL
20.2.24) to the Sensor.
4.
Align the Tension Bracket Assembly (PL 20.2.11) with the mounting position in
the Horizontal Transport, and secure it with two screws.
5.
Hook the Tension Spring to the holes in the Tension Bracket Assembly and the
Horizontal Transport frame.
6.
Mount the Horizontal Transport
.
.
Rear Cover
Volume 6 / Finisher - RRPs
S4525-422
6-715