Roll Dup - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.12.8 ROLL DUP

Removal
1. Remove the COVER LEFT. (p.353)
2. Remove the COVER RIGHT. (p.354)
3. Remove the HSG UPPER ASSY. (p.343)
4. Remove the HSG LOWER DUP. (p.344)
5. Remove the two screws (gold, tapping, 8mm) and ONE SCREW TAPPING
securing the COVER DAMPER to the COVER HSG DUP.
6. Remove the COVER DAMPER and SPRING DAMPER from the COVER HSG
DUP.
In the following steps, take care not to mislay the gears since the
C A U T I O N
working space is small.
7. Release from the inside the hooks of the three BEARINGs DUP located on the
side opposite to the GEARs ROLL, and remove the BEARINGs DUP from the
COVER HSG DUP.
8. Release the hooks of the three GEARs ROLL, and remove the GEARs ROLL
from the ROLLs DUP.
9. Move and remove the three ROLLs DUP in the direction of the arrow.
When removing the ROLLs DUP, take care not to hold their
C A U T I O N
rubber parts.
Disassembly and Assembly
8)
9)
BEARING DUP
7)
6)
SPRING DAMPER
COVER DAMPER
SCREW TAPPING
Figure 4- 151. ROLL DUP Removal
Option Duplex
ROLL DUP
8)
GEAR ROLL
8)
8)
COVER HSG DUP
GEAR ROLL
BEARING DUP
Confidential
Revision C
8)
JG3608AB
351