Guide Assy Cru R - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.7.12 GUIDE ASSY CRU R

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the FUSER ASSY. (p.253)
4. Remove the COVER LEFT. (p.169)
5. Remove the COVER RIGHT. (p.168)
6. Remove the COVER EXIT 500. (p.261)
7. Remove the 500 EXIT ASSY. (p.262)
8. Remove the COVER TOP, CONTROL PANEL. (p.170)
9. Remove the COVER FRONT. (p.172)
10. Remove the BTR ASSY. (p.254)
11. Remove the SHIELD ASSY ESS. (p.294)
12. Remove the SHIELD PLATE HVPS. (p.296)
13. Remove the DUCT FRONT, FAN SUB. (p.241)
14. Disconnect the connector (P/J31) of the GUIDE ASSY CRU R from the HVPS/
MCU.
15. Disconnect the connector (P/J15) of the HARNESS ASSY ANT from the HVPS/
MCU.
16. Remove the three screws (silver, 6 mm) securing the GUIDE ASSY CRU R.
17. Pull the harness of the GUIDE ASSY CRU R out of the frame.
18. Remove the GUIDE ASSY CRU R.
Disassembly and Assembly
P/J15
HVPS / MCU
SHIELD PLATE ESS
SHIELD
PLATE HVPS
Figure 4- 70. GUIDE ASSY CRU R Removal
Xero
31
15)
GUIDE ASSY CRU R
14)
16)
18)
JG3204AA
Revision C
257
Confidential