Roll Exit - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.8.4 ROLL EXIT

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the COVER LEFT. (p.169)
4. Remove the COVER RIGHT. (p.168)
5. Remove the COVER EXIT 500. (p.261)
6. Remove the CHUTE UP EXIT, CHUTE LOW EXIT. (p.263)
7. Release the hook of the GEAR 21, and remove the GEAR 21 from the ROLL
EXIT.
8. Release the hook of the GEAR 21 side BEARING EXIT, lift the ROLL EXIT, and
remove the BEARING EXIT from the ROLL EXIT.
Carefully handle the hook of the BEARING EXIT as it may be
C A U T I O N
damaged by application of large force.
9. Pull and remove the ROLL EXIT out of the opposite side BEARING EXIT in the
direction of the arrow.
In removal, take care not to hold any rubber portion of the ROLL
C A U T I O N
EXIT.
Installation
1. Move the ROLL EXIT in the direction opposite to the arrow, and install it to the
BEARING EXIT.
When installing the ROLL EXIT, take care not to hold any rubber
C A U T I O N
portion.
Disassembly and Assembly
2. Fit the BEARING EXIT to the GEAR 21 side ROLL EXIT, install the BEARING
EXIT to the CHUTE UP EXIT, and lock the hook.
3. Install the GEAR 21 to the ROLL EXIT.
4. Install the CHUTE UP EXIT, CHUTE LOW EXIT. (p.263)
5. Install the COVER EXIT 500. (p.261)
6. Install the COVER RIGHT. (p.168)
7. Install the COVER LEFT. (p.169)
8. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
9. Install the COVER REAR 500. (p.270)
BEARING EXIT ROLL EXIT
CHUTE UP EXIT
Figure 4- 76. ROLL EXIT Removal
500 Paper Exit
Revision C
7)
BEARING EXIT
GEAR 21
9)
8)
JG3080AA
Confidential
265