EPSON EPL-N3000/AcuLaser M4000N
3.2.15 Paper Out/Tray 1,2
Table 3-18. Troubleshooting for "Paper Out/Tray 1, 2"
Step
Action and Question
Parts below can be the source of this error
• SENSOR NO PAPER (p.222),
• ACTUATOR NO PAPER (p.223),
• HVPS/MCU
(p.301)
• LVPS
(p.287)
• PLATE ASSY BTM
(p.330)
• RACK BTM LOCK 550
(p.203)
• HOUSING BASE 550
(p.208)
♦
Is the Tray 3 or Tray 4 pointed out by error display? Go to
1
Presence of paper
2
1. Check Tray 1 or Tray 2 for paper.
♦
Is there paper in Tray 1 or Tray 2?
♦
Is each PLATE ASSY BTM raised properly?
3
Troubleshooting
Yes
(Chapter 4 Disassembly and
Assembly)
(p.232)
(p.238)
3.2.21
Paper Out/
Go to Step 2
Tray 3, 4
(p.87)
Go to Step 3
Supply paper.
Remove the
Paper Cassette
and install
Go to Step 4
PLATE ASSY
BTM
properly.
Troubleshooting When There is Error Display
Table 3-18. Troubleshooting for "Paper Out/Tray 1, 2"
Step
Action and Question
1. Clamp the ceenter part of RACK BTM LOCK 550
No
ageinst HOUSING BASE 550 while holding down
PLATE ASSY BTM.
♦
Is there any gap between RACK LOCK 550 and
HOUSING BASE 550?
RACK BTM LOCK 550
4
ACTUATOR NO PAPER
1. Remove the Paper Cassette.
5
2. Insert your hand through the cassette inserting
opening, and move the ACTUATOR NO PAPER.
♦
Does the ACTUATOR NO PAPER move
smoothly?
HVPS/MCU
6
1.
Replace the HVPS/MCU. (p.301)
♦
Dose the problem still occur?
Revision C
Yes
No
Reinstall the
RACK
Go to Step 5
BMTM
LOCK 550
(p.
203)
Replace the
Go to Step 6
ACTUATOR
NO PAPER
Go to
3.4.23
SENSOR NO
Problem
PAPER
solved
(p.131)
84
Confidential